• ARP Head Stud Kit for BMW S14 E30 M3 Engines
1 1

ARP Automotive Racing Products

ARP Head Stud Kit, BMW S14

ARP Head Stud Kit, BMW S14

$179.99 USD
$179.99 USD $179.99 USD
Oferta Agotado
Los gastos de envío se calculan en la pantalla de pago.

This ARP head stud Kit is designed for the BMW S14 B20, S14B23, S14B25, S14B27 engines found in the E30 M3. Installing ARP head studs can provide several benefits, including increased clamping force, improved head gasket sealing, and greater overall engine strength. This is especially important in high-performance and racing applications where the engine is subjected to increased stress and higher temperatures.

Before installing ARP head studs, it is important to properly clean and prepare the engine block and cylinder head mating surfaces. It is also recommended to use ARP Ultra-Torque Fastener Assembly Lubricant during installation to ensure proper torque and clamping force.

Overall, the ARP #201-4605 head studs are a great choice for BMW S14 engine builds and can provide increased reliability and performance.


Installation Instructions: 

1. To ensure proper thread engagement and accurate torque readings, clean ALL threads in the block. Chase if necessary with ARP Thread Chaser.
2. Clean and inspect all hardware prior to installation. Look for obvious defects or shipping damages, plus proper fit, length and dimension.
3. If the cylinder head studs protrude into a water jacket, lubricate the block threads of the studs with ARP THREAD SEALER.
4. Screw studs into the block “HAND TIGHT ONLY”.
5. Install the cylinder head(s) and check for binding or misalignment.
6. Lubricate the stud threads, nuts and washers with ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT.
Then install the washers and the nuts onto the studs and tighten them hand tight.
ARP recommends using the ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT that is provided with each kit as opposed to motor oil. This is due to higher friction on the studs as well as inconsistencies in the clamping force of the fasteners when motor oil or other low quality lubricants are used.

PRELOAD (TORQUE) RECOMMENDATIONS

7. Following the manufacturers recommended torque sequence tighten the nuts steps 1-3

Step 1: Tighten to 30 ft-lbs.
Step 2: Tighten to 60 ft-lbs.
Step 3: Tighten to 95 ft-lbs.

with ARP Ultra-Torque fastener assembly lubricant

Bolt Torque Sequence

7 3 1 5
 9
10 6 2 4 8

 

Please note: After initial assembly, it is necessary to allow the engine to complete a full heat cycle, then re-torque your head studs to spec. This means allowing the engine to warm up to its normal operating temperature, remain at operating temperature for several minutes to ensure each component is uniformly heated, then turned off and cooled completely to ambient temperature.

BMW S14 Applications:

BMW S14B20

1989-1991      E30     320is [Portugal and Italy]

BMW S14B23

1986-1991      E30     M3
1986-1987      E30     M3 Evo I
1988      E30     M3 Evo II

BMW S14B25

1990      E30     M3 Sport Evo (Evo III)

ARP-HSK-S14

Ver todos los detalles